resetImpl

Reset System object states

expand all in page

Syntax

resetImpl(obj)

Description

resetImpl(obj) specifies the algorithm that initializes or resets the states of a System object™. Typically you reset the states to a set of initial values, which is useful for initialization at the start of simulation.

resetImpl is called by the reset method only if the object is in use. The object remains as "in-use" after it is reset. resetImpl is also called by the setup method, after the setupImpl method. See Summary of Call Sequence.

Note

You must set Access = protected for this method.

You cannot modify any tunable properties in this method if its System object will be used in the Simulink® MATLAB System block.

Input Arguments

obj

System object

Examples

expand all

Use the reset method to reset the state of the counter stored in the Count property to zero.

methods (Access = protected)
   function resetImpl(obj)
      obj.Count = 0; 
   end
end

See Also

Topics

Was this topic helpful?
MATLAB Documentation
Support